Posts Tagged ‘save heat’
Heating My House With Only a Fireplace
We live in northern Wisconsin in a 40+ year old ranch home. Read here about the wood burning stove that we can now heat our home at temperatures down to zero degrees F! 
The wood burning stove pictured left heats our house thanks to the new blower system and many improvements in insulation I made this fall, documented on this blog and on my site SaveHouseHoldEnergy.com. Also, you will find a host of other resources for saving money while on a budget on this site, including a page on how I cut my oil hot water bill nearly in half, along with a homemade solar shower I constructed.
The stove is in our basement on the finished side. We live in a fairly modest 1200 square foot mid-sixties era ranch home with another 600 square feet of (somewhat) finished area in the basement. Our basement was always very cold so we decided to put in a free standing wood stove. The stove worked great, but much of the heat tended to stay in the basement, too much at times.
And our upstairs was not really getting much heat. To send more heat upstairs, I put in a floor grate (pictured on left) a few years back. This helped somewhat but still did not deliver a lot of heat. The way to get more heat upstairs was to install a blower run on a thermostat. The blower was purchased at Home Depot online and is nice in that it is fairly quiet. This blower is designed to be part of a 6″ stove vent pipe. The thermostat was purchased from kkontrols.com and works incredibly well. This is the same thermostat that is used in controlling temperatures on large greenhouses I see listed in seed catalogs. This blower will turn on, and stay on, as soon as heat builds up and will turn off, and stay off, when heat levels diminish. About the hardest part of rigging this whole system up was fishing the 14-2 wire through my finished basement ceiling to connect to a power source. For safety sake, consult or hire an electrician when installing this system.
Converting 4″ Walls to 6″ Walls and Adding Insulation
In the summers of 2005 and 2006, we converted our exterior bedroom walls from 4" (3.5" actual thickness) into 6" (5.5" actual thickness). This is a 57% increase in thickness, but since we also replaced some old compressed rock-wool insulation and added a vapor barrier, the R-value was perhaps doubled. And boy, do we feel a difference when the temps dip below zero! But, we still had our living room, kitchen, and bathroom remaining with 4" walls. So, with the high price of heating oil, I decided to tackle the South wall of our living room. To see a nice overview of the steps involved, go to This Article At NaturalHandyman that I wrote for them. Within the article are details of the projects and step-by-step photos. To see a video overview of this latest project, go to South Wall Insulation Project Video or play the video embedded below.
This is a messy project, but if you clean as you go, it is not bad. Once the painting is done, you are left with the "finishing touches" which consist of shortening trim and replacing other trim and extending window and door frames. This can drag on a bit since it is slow work, but at least it is not messy. I am still plugging away at my trim from our South wall project of late July. But it will get done. Still, this project is well worth the time if you live in a northern climate and you will appreciate the comfort of a well insulated house.
The cost of this South Wall Project was about $200. About $35 in new insulation, $40 in drywall, $80 in 2×4’s, and some more for window and door extenders, Great Stuff insulating foam, plastic, and other odds and ends. Not a lot to pay in my opinion, and money recovered in a few winters.